Dana 60 Kingpin Camber Adjustable Lower Cap

Dana 60 Kingpin Camber Adjustable Lower CapQuantity 2 needed to replace both sides. Dana 60 Kingpin Camber Adjustable Lower Cap. This cap replaces the lower kingpin cap completely and has an eccentric designed in to allow 3 of camber adjustment off center. Super easy install and adjustment. Often an original Dana 60 kingpin axle was manufactured or abused to allow otherwise non adjustable incorrect camber, both positive and negative. This is often so bad that it is noticeable on a visual

Quantity 2 needed to replace both sides. 

 Dana 60 Kingpin Camber Adjustable Lower Cap. This cap replaces the lower kingpin cap completely and has an eccentric designed in to allow 3° of camber adjustment off center. Super easy install and adjustment. 
   Often an original Dana 60 kingpin axle was manufactured or abused to allow otherwise non adjustable incorrect camber, both positive and negative. This is often so bad that it is noticeable on a visual inspection from the front of the truck. 
   Of course this will have a negative effect on tire wear but also steering and handling feel. 
   Back when these axles were commonly in alignment shops there were a variety of parts available to remedy this, but they have mostly since disappeared since these are all older axles at this point. Worse yet, many of the least expensive fixes required a lot of axle disassembly. 
   This product couldn’t be easier to install or adjust!  Get that 1st Gen Cummins or any other kingpin dana 60 or 70 equipped rig properly aligned and driving much better than it would with these issues. 
   Modifies one side of the vehicle.