Hollyland Spares - Lark MAX Charging Case (Black)

The Hollyland LARK MAX Replacement Charging Case in Black is the official standalone power vault and hardware organizer engineered exclusively for the flagship LARK MAX wireless system.

If your original case was lost, suffered water damage on a shoot, or stopped holding a charge, this replacement restores your full production mobility. It acts simultaneously as a rugged protective storage bunker, a multi-device rapid power bank, and an automatic hardware synchronization station.

Key Capabilities & Power Metrics

• Massive 2800 mAh Reserve Battery: Houses a high-density lithium-polymer battery cell. When completely topped up, it holds enough power to fully recharge the entire dual-microphone system (2 × Transmitters + 1 × Touchscreen Receiver) up to 2 consecutive times.

• 30-Hour Total System Expansion: Utilizing the case to dynamically charge your gear between interview setups increases your aggregate operational field time from 7.5 hours (on individual transmitter batteries) to a maximum of 30 hours.

• Smart Auto-Pairing Pins: The case is molded with precise magnetic docks lined with gold-plated contact pins. Dropping a replacement microphone or a newly sourced receiver into its respective tray automatically forces frequency pairing and syncs the hardware in under 5 seconds.

• Front-Facing Fuel Gauge LEDs: Four clear, low-draw LED indicator lights on the front of the matte chassis show the case's remaining charge level at a glance, so you never head out to a shoot with an empty power bank.

Hardware Technical Specifications Matrix

Syncing New Hardware Inside Your Replacement Case

If you are using this new replacement case to sync mixed hardware components (such as an old transmitter combined with a newly replaced receiver), follow this straightforward sequence:

1. Place both transmitters (TX) into the outer slots and the main touchscreen receiver (RX) into the center slot of the new charging case.

2. Ensure the gold contact terminals on the bottom of the devices are clean and free of lint.

3. Snap the case lid shut firmly.

4. The internal charging circuitry will instantly trigger. The receiver's screen will illuminate inside the case, showing an animated charging graphic alongside a hardware pairing confirmation. Within seconds, your wireless network is fully matched and calibrated for deployment.

Storage Organization Hint: The inner lid of the case features a recessed layout designed to accommodate the clip-on spring structures of the transmitters. You do not need to remove the small magnetic clips from the backs of your LARK MAX mics before docking them; the slots provide sufficient structural clearance to close and latch the lid completely without crushing the hardware framework.